Enzo Subtank Instructions

The Enzo Subtank System is an aftermarket performance upgrade kit made for motorcycle front forks that is manufactured by Enzo Racing. The subtank system provides speed sensitivity to the front motorcycle springs and forks. By manipulating the air spring in the fork, the subtank system adds speed sensitivity to the fork spring. This is accomplished by compressing the front end at slower speeds. It takes approximately one to two hours to install the subtank system on a motorcycle.

Things You'll Need

  • Screwdriver
  • Nut driver
Show More

Instructions

    • 1

      Use a screwdriver or nut driver to remove the front number plate from the motorcycle.

    • 2

      Fasten the triple clamps by hand to the front forks at the needed height, with the hose cap fitting facing the front.

    • 3

      Slip the subtanks into the clamps. Tighten the end of the hose onto the subtank and then loop it around the cap fitting.

    • 4

      Sit on the motorcycle and turn the handlebars from side to side to check to make sure subtanks and hoses do not interfere with the hoses or cables on the motorbike. Position the hoses or cables by looping them by hand so they do not interfere.