How to Package a Road Bicycle for Shipping

Bikes can put up with a lot of wear and tear on the road, but that doesn't mean they can't get damaged during shipping. It's important to package your bicycle properly so that it doesn't get bumped around in the box and you still have all of its vital parts when it arrives at its destination. It only takes a few simple packing materials and a little effort to pack your bike properly.

Things You'll Need

  • Bike box Rag Allen wrench Fork block Bubble Wrap Package tape Crescent wrench
Show More

Instructions

  1. Instructions

    • 1

      Find a cardboard bike box. Most bike shops have extras that can be yours just for the asking. If not, get one from a self-storage center or a store that sells shipping supplies.

    • 2

      Wipe down your bike with a wet rag so you don't end up with a box full of leaves and dirt. Then put your bike on the largest gear and let out about half of the air from your tires. Do not start packaging your bike until it is dry.

    • 3

      Use your wrenches to unscrew the handlebars, seat, front wheel and both pedals, and wrap each in a thin sheet of Bubble Wrap, taping it so that it stays secure. Put the fork block in the space where the front wheel was attached to keep the fork dropout from getting damaged or tearing your box. (The fork block resembles a plastic dowel and should slide easily into the spot for the wheel's axle.)

    • 4

      Wrap the frame with Bubble Wrap, being sure to cover all the tubes. Tape all of the parts you removed in step three securely to the frame, keeping everything tight and close. Lay the box on its side and gently slide the bike inside. Close the box and move it from side to side listening for any shaking or rattling. If you hear anything, add more Bubble Wrap and then try again.

    • 5

      Seal the box with package tape and reinforce the bottom with additional tape. Be generous in your taping so that your bike has no chance of falling out.