How to Remove an M2R Helmet Liner

Made2Race Helmets of Australia manufactures helmets for on- or off-road motorcyclists -- from recreational hobbyists to elite racers. Though the construction of the various helmets differs -- from thermo-alloys to kevlar composite technology -- the layout is largely the same and has been for years. The lining inside each helmet can be luxurious or utilitarian, but most can be removed to allow for easy odor reduction.

Instructions

  1. Remove Faceless Off-Road Helmet Liner

    • 1

      Unsnap the M2R liner's cheek pads and pull them from the chin straps.

    • 2

      Unattach the two snaps at the back of the liner, near where the neck is placed.

    • 3

      Pull out the liner and disconnect the tabs at the forehead section of the helmet.

    Remove Full-Face Helmet Liner

    • 4

      Unsnap the cheek pads from each side, and remove the pads from the chin strap.

    • 5

      Pull down on each cheek pad from the front section to disengage the tension clips for the liner.

    • 6

      Unsnap the snaps for the liner at the neck and forehead area. Pull down to remove the main liner.

    • 7

      Remove the faceplate liner by removing the snaps and tabs that hold it on to the base liner.