How to Adjust the Regulator Pressure on an Autococker

The Autococker is a paintball gun that comes equipped with various features, such as an auto-cocking system. This system functions via the CO2 cartridge that is connected to the gun. The gun also comes with a regulator adjustment knob that controls the pressure of the C02. You can adjust this pressure whenever you feel the gun isn't performing as it should.

Things You'll Need

  • Safety goggles
Show More

Instructions

    • 1

      Put on your safety goggles and unscrew the barrel of the gun to ensure that there are no paintballs in the barrel. Replace the barrel of the gun.

    • 2

      Locate the regulator adjustment knob at the end of the gun, just below the barrel. Turn it about one revolution counter clockwise. This will loosen the regulator.

    • 3

      Install a C02 cartridge in your gun by screwing it into the receiver port just in front of the trigger guard.

    • 4

      Pull the trigger as far back as it will go and hold it in that position.

    • 5

      Turn the regulator knob clockwise slowly.

    • 6

      Pull and release the trigger repeatedly as you turn the knob. Continue until the gun fires. You do not need to turn the knob any more as the regulator is properly adjusted and set.