How to Disassemble a Comarksman Repeater

Disassembling a Marksman Repeater BB Gun is necessary in order to repair a jammed or damaged spring mechanism in the gun or to replace any of the interior parts. Occasionally, the spring mechanism of the gun will wear out and prevent the gun from operating properly. The gun is held together with screws and you can disassemble the device with a few common tools.

Things You'll Need

  • Small flat head screwdriver
  • Needle nose pliers
  • Phillips screwdriver
Show More

Instructions

    • 1

      Remove the cover plates on both sides of the Marksman Repeater BB Gun handle with a small flat head screwdriver and set the plates aside.

    • 2

      Slide the lever back until it locks in place and remove the clip on the back of the lever with needle nose pliers. Take the lever off the gun and set it out of the way.

    • 3

      Place the gun on its side and unfasten the screws holding the two gun halves together with a Phillips screwdriver.

    • 4

      Hold the two halves together and slowly separate them to remove the spring mechanism from the back of the gun.

    • 5

      Place the gun on its side on a table and carefully lift one side of the gun away from the other. Remove the parts from inside the gun and set them aside so you can locate them when you are ready to reassemble the gun.