How to Make Ramps for My Techdeck

The Tech Deck corporation manufactures hand held designs of street skateboards. The miniature skateboard comes equipped with all the components of a regular board including grip tape and metallic trucks. Use the forefinger and middle finger of your dominant hand to perform Tech Deck maneuvers and tricks. According to Tech Deck, the signature Tech Deck ramps offer an attachable design that allows you to create your own custom skate park. Instead of buying a Tech Deck ramp, create a homemade ramp by utilizing a few household items.

Things You'll Need

  • Cereal box
  • Scissors
  • Duct tape
  • Stickers
  • Markers
Show More

Instructions

    • 1

      Remove the plastic package from the inside of your cereal box. Use scissors to cut off the top tabs of the pliable cardboard box. Place the scissor blades onto one of the four corners located at the top of the box. Cut halfway down the creased edge. Repeat the process with the remaining three sides of the cereal box.

    • 2

      Rotate the box upside down and lower it onto a flat table. Push down on the box to splay the newly-cut pieces. Cut out four strips of duct tape that measure one inch in length. Apply tape to each of the sloping sides of the Tech Deck ramp to fasten it to the table.

    • 3

      Roll your Tech Deck up your homemade ramp to ensure it has a stable construction. Remove the tape and cut the edges further to lower the height of your Tech Deck ramp. Reapply the duct tape if you make any height adjustments.

    • 4

      Locate the small stickers that have been included with your Tech Deck board. Apply the stickers onto the sloping sides of the pyramid-shaped Tech Deck ramp. Draw any designs or pictures on the cardboard box to customize your homemade Tech Deck ramp.