How to Remove the Ejector From a Kel-Tec P11

The Kel-Tec P11 is a lightweight, semi-automatic pistol designed for undercover police to conceal. The ejector is the mechanism in the chamber that pushes the brass casing out of the barrel after the bullet has been fired. Removing the ejector from the pistol requires basic disassembling procedures. Although this process might seem intimidating, it's straightforward and takes only a few minutes.

Things You'll Need

  • Brass bullet case
Show More

Instructions

    • 1

      Unload the weapon and remove the bullet from the barrel by pulling back the slider and ejecting the bullet.

    • 2

      Pull the slider back all the way and push the slide lock on the left side of the gun up until the slider locks in place.

    • 3

      Remove the assembly pin -- found on the left side of the gun directly beneath the center of the barrel -- using the edge of a brass bullet casing.

    • 4

      Hold the slider back and slowly push the slide lock down all the way. Slowly slide the slider forward and off the frame.

    • 5

      Remove the recoil pin found at the back of the barrel and slide the barrel out of the frame to dislodge the ejector. Grip the ejector and gently slide it off of the frame.