Assembly Instructions for the Tactical SERPA Holster

The SERPA holster system is designed for tactical operations, such as those encountered in law enforcement or military operations. The SERPA holsters have hard plastic fixtures that allow custom canting for your sidearm and body positioning. Assemble the holsters requires little more than threading the nylon straps through the slits. The crux of setting up the holster is adjusting the canting to have your sidearm face muzzle-forward or butt-forward. Assemble and adjust the holster in as little as five minutes.

Things You'll Need

  • Phillips screwdriver
Show More

Instructions

    • 1

      Set the hard plastic sidearm holster on a flat surface. Place the two nylon straps to the sides. Ensure you have the top strap next to the top SERPA holster slit and the bottom strap next to the bottom slit.

    • 2

      Thread the straps through the respective slits, pushing up on the slit to get the clips through.

    • 3

      Flip the entire holster unit over. Locate the three retaining screws on the back of the black plastic. Unscrew and remove them, carefully setting them to the side. Watch for the safety loop as you pull the screws out of the housing. If it gets in the way, simply push it to one side.

    • 4

      Push the canting to either the muzzle-forward or butt-forward position.

    • 5

      Screw the three retaining screws back into the holster to lock it into your chosen canting position.

    • 6

      Holster your sidearm (unloaded to test) into the SERPA. Push it in until you hear it click into the housing. Remove the sidearm and attach the holster to your body or belt. Holster your sidearm.