Two-Room Cabin Tent Set-Up Instructions
Things You'll Need
- Hammer
- Stakes
- Front, middle and rear tent poles
- Rain fly
Instructions
-
-
1
Locate a level campsite, and unroll your tent. Hammer the stakes into the ground through the loops at the corners of the tent base. Fully extend all of the tent poles; separate them into the front, middle and rear sets.
-
2
Slide the top-left, front tent-pole through the elastic loop and pole sleeve; secure the loop onto the "C" clip. Repeat the process for the top-right, front tent-pole. Slide the two poles together.
-
3
Slide one of the front leg-poles into one end of the top-front tent pole. Insert the metal pin -- located at the base of the tent -- into the other end of the pole. Repeat the process for the remaining front leg-pole.
-
4
Put the middle roof-pole through the sleeve on the center of the tent's roof. Slide the pole into the elbow hubs on each end of the pole, locking them in position.
-
5
Slide one of the middle leg-poles into one of the center-elbow hubs. Insert the metal pin -- located at the base of the tent -- into the other end of the leg pole. Repeat the process for the other middle leg-pole.
-
6
Insert each end of the V-shaped rear pole into the elbow connectors on the back tent-corners; lock them in position. Connect the plastic clips from the tent to the pole; this holds it in place.
-
7
Slide one of the rear leg-poles into one of the elbow hubs. Insert the opposite end into the metal pin at the tent base. Repeat the process for the remaining rear tent-pole.
-
8
Lay the rain fly over the rear room of the tent. Hook the "J" ring to the loop located next to the metal pins at the tent base. Tie the tent fasteners to the middle leg-pole. Hang the room divider with the attached toggles to the loops on the interior walls.
-
1
sports