How to Install a Velcro Pressure Switch

When using your firearm at night, it is difficult to hold the gun and flashlight at the same time. The solution is to mount the light onto the gun. This allows you to keep both hands on the firearm, and provides light in the direction you are aiming. To simplify turning on and off the light, a Velcro pressure switch is installed over the light's battery cap, and the switch is fastened on the grip with Velcro.

Instructions

    • 1

      Unscrew the back of the flashlight's battery access cap by turning it counterclockwise.

    • 2

      Screw the pressure sensor's cap onto the back of the flashlight by turning it clockwise.

    • 3

      Run the pressure sensor's wire toward the grip, along the frame in a way that doesn't affect the operation of the gun.

    • 4

      Remove the film over the adhesive on the pressure switch's Velvro. Push the switch onto the grip in the position that most comfortably allows you to operate it.

    • 5

      Turn the flashlight's switch to the "On" position. Turn the flashlight on and off by applying pressure to the switch.