How to Install a Ski-Doo Heated Visor Plug

A fogged up helmet visor is the last thing you want to have to worry about when you're cruising at top speed on your Ski-Doo. A fogged up visor mask can block your vision and make for a very dangerous scenario. That's why Ski-Doos come equipped with special heated plug-ins that are designed just for defrosting helmet visors. If the wiring on the plug goes bad, or if the plug just wears out, it can be replaced fairly quickly.

Things You'll Need

  • Socket set
  • Adjustable wrench
  • Replacement visor plug
Show More

Instructions

    • 1

      Lift the engine cover and remove the negative battery cable.

    • 2

      Remove the center piece between the handlebars.

    • 3

      Use an adjustable wrench to loosen and remove the jack plug.

    • 4

      Lift the old plug assembly out. Unplug it from the old wiring harness. Plug the new heated jack into the wiring harness and slip it back into place.

    • 5

      Replace the jack screw with the adjustable wrench.

    • 6

      Replace the Ski-Doo's negative battery cable with the socket set and close the engine compartment. Start the Ski-Doo and plug in the helmet to make sure the heated visor is working.