How to Install the Head on a Bogen Tripod

Bogen tripods are used for camcorder and still photography cameras. These tripods are heavy, stout and built to withstand the rigors of inclement weather and elements. A head piece attaches to the center-top of the tripod and allows 360-degree turns and pivots. These tripods are handy when using heavy lenses or bulky cameras. Once the head is installed, mount the camera and use the pivots or swivel to gain access to the desired target for the shoot.

Things You'll Need

  • Hex wrench
  • Flathead screwdriver
Show More

Instructions

    • 1

      Set the two pieces of the head casing on a flat surface. Place the gaskets onto the sides of the casings. Bring them together and align the four set-screw holes. Screw the four set-screws to bring the head into the solid structure needed to mount onto the tripod.

    • 2

      Unscrew the attachment dial on the underside of the tripod center where the three legs meet in the upper portion of the tripod. Expose the attachment screw on the top of the mounting plate.

    • 3

      Place the head onto the attachment screw and turn it clockwise by hand until it is firm on the mounting plate. Turn the dial under the plate all the way clockwise until it is tight in position against the plate.

    • 4

      Turn the head 360 degrees to ensure the dial and screws are not too tight and allows the full 360 swivel. Mount the camera to the head and tilt it to test the pivots.