How to Adjust the Straps on the Flow Quattro

Flow bindings have a cult following. The unconventional, uni-body strap provides superb hold without the added bulkiness found in other brands. Flow Quattros are designed for skiers desiring a flexible yet supportive binding that adapts to everything from icy halfpipes to steep mountain terrain. Initial strap setup is simple. Once you have them dialed, minimal on-hill adjustments are needed.

Things You'll Need

  • Snowboard
  • Flow Quattro bindings
  • Snowboard boots
Show More

Instructions

    • 1

      Lay your snowboard, mounted with Flow bindings, on the floor or carpet.

    • 2

      Release the highback by pulling down on the lever.

    • 3

      Press the ratchet tabs on all four of the instep pad's straps to release their lock. Slide the pad to accommodate the largest setting.

    • 4

      Insert your snowboard boot into the binding.

    • 5

      Adjust the instep pad to your boot by pinching and sliding each of the four ratchet tabs located on the ladder straps. Work from front to back until you have a tight fit.

    • 6

      Flip up the lever at the rear of the highback. Note if the strap tension is to your liking.

    • 7

      Disengage the highback to fine-tune the straps, if necessary.

    • 8

      Reengage the highback again to check your adjustments. If you have difficulty obtaining your desired fit, check to make sure you have the correct binding size for your boot.