How to Install Morrow Invasion Bindings

Morrow offers a plethora of snowboarding gear including boots, boards and bindings. The Invasion bindings from Morrow feature a durable yet lightweight design that's made with aluminum and injected nylon components. The retention straps of the Morrow bindings are padded with EVA foam to provide a comfortable yet snug fit. The snowboarding deck is equipped with numerous mounting holes for easy binding installation and adjustment.

Things You'll Need

  • Phillips head screwdriver
Show More

Instructions

    • 1

      Lower the underside of your snowboard onto a level worktable to begin the installation process. Loosen the two retention straps of the Morrow bindings. Remove the aluminum base plates from the footbeds of the bindings.

    • 2

      Choose the Morrow binding that corresponds with your lead foot. Lower the binding over the centermost mounting holes located at the front of the snowboard. Rotate your lead binding to the desired angle to ensure a comfortable riding stance.

    • 3

      Align the corresponding base plate into the footbed of your lead binding. Insert the four binding screws through the top of the base plate and into the center mounting holes. Turn the screws clockwise, using a Phillips screwdriver, and fasten the Morrow binding in place.

    • 4

      Align the remaining binding over the centermost mounting holes located at the back of the snowboard. Lower the corresponding base plate into the footbed of the Morrow binding. Insert the four binding screws through the base plate and into the mounting holes.

    • 5

      Tighten the screws to complete the binding installation process. Lower your boots into the bindings to ensure the riding stance meets your specifications. Loosen the screws of the Morrow bindings to make any necessary adjustments.