Instructions for the KM2 Cheetah Board

Playing paintball with your friends and family can be a fun way to spend a few hours outside, but you can quickly lose the match if your gun jams. To prevent your paintball gun from jamming while in the heat of battle, you can install a special device called a KM2 Cheetah Board. Once this device is installed on your gun, it will automatically clear out any paint balls that get stuck in the gun, ensuring every shot will leave the barrel.

Instructions

    • 1

      Press and hold down the "Power" button on the top of the Cheetah Board for three seconds and let go. The LED on the back of the unit will light up and turn pink. It will slowly transition from pink to blue while it warms up and then yellow when it is ready for use.

    • 2

      Open the paint ball compartment on your gun and insert paint balls inside as you normally would. As you insert the balls, you will hear the Cheetah Board spinning to let the balls through the unit and into the barrel of the gun. Once the compartment is full, close the lid.

    • 3

      Begin playing the game as usual. As you begin to fire, the light on the Cheetah will turn blue to indicate it is in automatic unjam mode which means it will spin the opposite direction to fix a jam if one occurs. Press and hold the "Power" button for four seconds until the light turns purple, and let go to enter the manual mode in which you will need to remove jams yourself.

    • 4

      Press the "Power" button once quickly to perform a manual unjamming of the gun. You will hear the unit spin backward to remove the paint ball that is jammed and then it will return to its normal operation. You can perform this task while in either manual or automatic mode. Hold the "Power" button until the light turns off to power down the Cheetah Board.