DIY Snowboard Hangers

Making your own inexpensive snowboard hanger will allow you to safely stow your snowboard during the off-season, while still being able to admire it. Hanging your prized board on the wall will keep the underside waxed surface safe from getting scratched, while also acting as a type of visual art in your home. You can make this simple hanger in a matter of minutes and it will stand the test of time.

Things You'll Need

  • Spirit level
  • Measuring tape
  • Drill
  • 2 Drywall anchors
  • 2 Drywall screws
  • 2 rubber washers (small)
Show More

Instructions

    • 1

      Measure the width of the board at the center, and also at the tip. Snowboards generally incorporate flared tips and tails to facilitate carving; add the two measurements together then divide the total by 2. This measurement will be the distance you should space your mounting holes apart.

    • 2

      Hold a spirit level up to your wall and mark the location of the two mounting holes with the measurement calculated in Step 1.

    • 3

      Drill out the two holes, then insert two plastic drywall anchors into them. If you're mounting your board on a solid wall, you can skip this step.

    • 4

      Place two small rubber washers onto the screws, then screw them in to the wall. The two rubber washers should sit flush against the wall, but be thick enough to hold up the board's edges.

    • 5

      Hang your board on the wall by placing the center of the board between the two screws, then lower it until the edges at the tip rest on the two rubber washers.