How to Troubleshoot a Nordic Track C2500
Things You'll Need
- Hex key
Instructions
-
Power Turns Off When You're Using the Treadmill
-
1
Check the reset switch on the bottom of the treadmill near the power cord. If it has tripped, the top of the switch will protrude. Wait 5 minutes then press the switch.
-
2
Check that the power cord is plugged in completely. If it is plugged in, unplug it, wait 5 minutes then plug it back in.
-
3
Remove the magnetic key from the console then reinsert it.
The Console Won't Turn Off
-
4
Insert the magnetic key into the console. Your C2500 is stuck in demo mode if the console won't turn off after you remove the magnetic key from the console.
-
5
Hold the "Stop" button down for a few seconds.
-
6
Press the "Speed" down (-) button. Remove the magnetic key.
The Incline Does Not Change Correctly
-
7
Press and hold the "Stop" and the "Speed" up (+) button. While holding the buttons, insert the key into the console, then release the buttons.
-
8
Press either the "Incline" up or down arrow button. Wait while the incline raises and lowers. This recalibrates the incline system.
-
9
Remove the key from the console.
Walking Belt Slows
-
10
Unplug your C2500 and remove the key from the console.
-
11
Turn both rear adjustment bolts, located on the back of the walking deck, to the left, a 1/4 turn.
-
12
Lift the edge of the walking belt in the middle of the deck. You should be able to lift it 2 to 3 inches off the walking platform. If the belt is still too tight, loosen the bolts another 1/4 turn each.
-
13
Plug the treadmill in and reinsert the console key. Walk on the belt at a slow speed to see if it still slows. Repeat Step 2 if necessary.
-
1
sports